Where can I find end caps: Metal and Square

[Riskdude]

Evening All:

I have been searching, unsuccessfully, for METAL end caps for some square tube I am using. I have found a bazillion plastic ones, I even have some, but I kinda think metal will stand up to the heat better than plastic.

There are round metal endcaps, end plugs, etc but I cannot locate square ones. I am looking for 1 1/2 by 1 1/2 inch.

Does anyone have a place I can find some? Thanks.

RiskDude.
_________________
Vertical Offset
Weber 18.5 WSM
Bunch a loose steel lying around.

[Wreckless]

[url]www.sss-steel.com
If you don't see it listed, give them a shout, they have more than they list. Nice place to do business.[/url]
_________________
Backyarder
Smoker Grill
Trailer Rig

[whiteboycustom]

what about plate and cutting out caps and welding them up???


most common caps that i sell is this......


_________________
Smokin' Aces Competition BBQ Team

[Riskdude]

Thanks. I am trying to do this build with no welding so I am looking for press in metal end caps.
_________________
Vertical Offset
Weber 18.5 WSM
Bunch a loose steel lying around.

[dpaulson]

Try Industrial metals I am sure there is one in Orange county If not a company that sells to metal fench fabricators

[ggarner]

http://www.mcmaster.com/#push-on-caps/=8y7lfz

about 3/4 of the way down the page. Hope that helps.

Ooops... i clicked metal caps and then square tubing... but those are still vinyl

[k.a.m.]

Riskdude, here is one I found that might help.
http://www.wagnercompanies.com/post_caps.aspx
_________________
Always remember slow and steady wins the race.

Hybrid Cooker

[Riskdude]

Thanks Everyone!! K.A.M, thanks!! I placed my order for the drive in end caps, which is exactly what I was looking for. I am getting close to final assembly and these were some of the last pieces I needed. I appreciate everyones help.
_________________
Vertical Offset
Weber 18.5 WSM
Bunch a loose steel lying around.